Bull Dog  
TOLL FREE: 1-877-962-0205   
LOCAL: 937-962-4140   
FAX: 937-962-4160   
Home » Products   
My Account  |  Cart Contents  |  Checkout   

Locks

Plunger Pins

Accessories

Plates

Components

Kits

Thermoforming Plastic & Foam Blanks

PVA Sleeves & Liquid Silicone

Fabrication Tooling

Silipos Products
Torque SettingsTorque Settings
Shuttle LocksShuttle Locks
Oven InstructionsOven Instructions
Laminating/Thermo. Inst.Laminating/Thermo. Inst.
Terms and ConditionsTerms and Conditions
Privacy PolicyPrivacy Policy
DisclaimerDisclaimer
Contact UsContact Us
Printable CatalogPrintable Catalog
Site MapSite Map
more
Fein MultiMaster Top Kit
Fein MultiMaster Top Kit
Please log in for prices 
Oven Instructions

IR OVEN INSTRUCTIONS AND
NOTES FOR CONVECTION OVEN

  1. Pre-heat oven to 365º F and prime vacuum systems.
  2. Prepare positive model by setting up fixture on distal end (such as TF-65) and use plaster to blend the edges. 
  3. Perform regular prep on positive model.
  4. Place aluminum support ring (RM-AS) in oven supporting it by at least two  sides (RM-CK support kit may be needed) making sure the inside diameter (I.D.) of the support ring is open. 
  5. Place ringmaster sheet on the aluminum support, then place second aluminum support ring (RM-AS) on top centered with plastic.  Heat inside oven for approx. 15 min. When plastic droops (1/2- to 2/3 of model), open oven and pull the rack out.  Grab the ringmaster and frame, take to model, flip like normal blister forming, pull down with a slight twisting motion and apply vacuum. 
  6. When cooled, take flat head screw driver and place between aluminum support and plastic then twist (this will separate the plastic and support). Remove the ring.
  7. Now make trim lines and cut socket.

Note:
When using in a convection oven, flip the plastic as necessary to keep even wall thickness



Copyright © Bulldog Tools
TOLL FREE: 1-877-962-0205
LOCAL: 937-962-4140
FAX: 937-962-4160